| Type |
Pre- main amplifier |
| < Power amplifier section
> |
| Rated output (20Hz - 20kHz) |
80W + 80W (8 Ω)
90W + 90W (6
Ω) |
| Input sensitivity/impedance |
Processor loop input: 150mV/30k Ω |
| Total height harmonic wave distortion
factor |
0.007% (20Hz - 20kHz and 40W, 8
Ω) |
| Cross modulation distortion factor |
0.003% (80W suitable, 8 Ω) |
| Dynamic power |
160W/2 Ω |
| TIM strain |
Below measurement limiting value |
| Through late |
Above ±150V/ μ sec |
| Output bandwidth |
5Hz - 80kHz (40W, 0.1% and 8 Ω) |
| Frequency characteristic |
4Hz - 150kHz, +0 -3dB (1W, 8 Ω) |
| Output impedance |
0.1 Ω Or less |
| Output terminal |
Speaker: AorB: 6 - 16 Ω, A+B: 12 - 16
Ω
Headphone jack installed capacity: 290mW (8 Ω), 8 - 400 Ω
conformity |
| < Pre-amp section
> |
| Input sensitivity/impedance |
Phono MM: 2.5mV/47k Ω
Phono MC: 0.2mV/200
Ω
CD and Video1, 2, AUX/Tuner and Tape1, 2: 150mV/30k
Ω |
Installed capacity/rated output
(processor
loop output containing) |
10V/150mV |
Total height harmonic wave distortion
factor
(processor loop output containing) |
0.002% (1kHz and 10V) |
| RIAA deviation |
20Hz - 50kHz±0.3dB (MC IN - processor loop
output containing) |
| < Synthesis
> |
Signal-noise ratio
(input short circuit and
auditory sensation weighting A) |
Phono MM: 82dB (at the time of 2.5mV
input)
Phono MC: 62dB (at the time of 0.25mV input)
Line:
105dB (at the time of 150mV input) |
| Tone control quality |
Bass: ±10dB (100Hz)
Treble: ±10dB
(10kHz) |
| The sub sonic filter for Phono |
16Hz, -12dB/oct |
| Picture in efficiency |
Frequency characteristic: DC -
10MHz±1dB
Rated voltage/impedance: 1C$vp-p75 Ω |
Electric power consumption
(electric
supplies control method) |
150W |
| Power source |
AC220V and 50Hz/60Hz |
External size
(the foot, the knob and the
terminal etc. are included) |
Width 434× height 137× depth
385mm |
| Weight |
9.5kg |